Problem 2 — Transient of RL network (15 pts) An inductor L=50 mH, resistor R=10 Ω, and a 5 V step source are connected in series. At t=0 switch closes. a) (7 pts) Derive i(t) for t≥0. b) (4 pts) Compute the energy stored in the inductor at t = τ (one time constant). c) (4 pts) Numerically evaluate i(t) and stored energy at t=τ. (Show numeric τ.)
Part D — Essay & synthesis (20 pts) Choose one of the two prompts (answer thoroughly, ~300–500 words):
Duration: 3 hours Total points: 200
Prompt B — Historical & conceptual reflection: Discuss how the transition from analog to digital signal processing changed circuit design priorities in power, bandwidth, and noise, citing specific examples (filters, amplifiers, communications receivers). Include one prediction for the next major shift in EE design over the next decade.
Problem 4 — Resonant circuits & bandwidth (12 pts) A series RLC has R=20 Ω, L=100 μH, C chosen so resonant frequency fr = 1 MHz. a) (4 pts) Find C. b) (4 pts) Compute Q factor and bandwidth (BW). c) (4 pts) If R is halved, state qualitatively how fr, Q, and BW change.
Problem 5 — Op-amp design (15 pts) Design an inverting amplifier with gain -10 using a real op-amp whose open-loop gain Aol(s) ≈ 10^5/(1 + s/2π·10 Hz). a) (6 pts) Choose Rf and Rin values (standard decade resistances) to realize the closed-loop midband gain -10 and justify choice. b) (5 pts) Compute the closed-loop bandwidth approximately using op-amp open-loop dominant pole. c) (4 pts) Discuss one stability concern with using very large feedback capacitances in the feedback network.
Problem 3 — AC steady-state & phasors (18 pts) Given: Vs = 10∠0° V, series network: R=50 Ω, L=100 mH, C=10 μF, frequency f=1 kHz. a) (6 pts) Convert L and C to reactances; compute total impedance Z and current phasor I. b) (6 pts) Compute voltage phasors across each element and verify KVL. c) (6 pts) Compute real power delivered by the source and reactive power.
Prompt A — Innovation case: Propose a compact, low-cost power-supply module for a battery-powered sensor node requiring 3.3 V at 100 mA from a 3.7 V Li-ion cell. Include topology choice, efficiency considerations, thermal constraints, component selection rationale, and brief EMI mitigation strategies.